28
Lever Blade Removal
Ultimate
: Use a T10 TORX
®
wrench to remove each lever pivot bolt.
TLM/TL
: Use a 2 mm hex wrench to rotate the reach adjust counter-
clockwise and set the reach adjust position to the minimum setting.
TLM/TL
: Place the lever body on the edge of a table, allowing the pivot
pin to hang off of the side of the table, then insert the SRAM aftermarket
lever pivot tool into the pivot pin slot.
TLM/TL
: Use a plastic mallet to tap the pivot pin until it dislodges from
the lever body completely.
Remove the inboard spring from the spring hole.
T10 TORX wrench
15 N•m (133 in-lb)
22 mm
8
2 mm Hex wrench
15 N•m (133 in-lb)
22 mm
AM SRAM TOOL LEVER PIVOT TOOL
15 N•m (133 in-lb)
22 mm
Plastic Mallet
15 N•m (133 in-lb)
22 mm
9
