SRAM GUIDE RSC 2015, Руководство по обслуживанию

Страница: 13 / 30

13 Piston Assembly Installation
P i s t o n A s s e m b l y I n s t a l l a t i o n
N OT I C E
DOT fluid will damage painted surfaces. If any fluid comes in contact with a painted surface (i.e. your frame) or printing on the brakes,
wipe it off immediately and clean it with isopropyl alcohol or water. Damage to painted and/or printed surfaces by DOT fluid is not
covered under warranty.
Submerge the new piston assembly in Avid High-Performance 5.1
DOT Fluid by hand.
You can also use Avid DOT Grease, or DOT 5.1 or 4 compatible
grease, as a lubricant.
Install the new lubricated piston assembly into the lever body.
Spray isopropyl alcohol on the lever body and both of your gloves
and clean with a rag.
Use the SRAM Guide Lever Internals Assembly Tool to press the
piston into the lever body while inserting the contact adjust knob
into the contact adjust slot.
You should hear a pop sound when the contact knob is fully seated
in place.
1
Avid High-Performance 5.1 DOT Fluid Avid High-Performance 5.1 DOT Fluid 22 mm
2
3
SRAM Guide Lever Internals Assembly Tool Avid High-Performance 5.1 DOT Fluid 22 mm
SRAM Guide Lever Internals Assembly Tool Avid High-Performance 5.1 DOT Fluid 22 mm