Model SR565
i
Bariatric Stand-On Scale
Operating and Service Manual - S/N 1000+
Part No. MAN565
i
_130314
Page 5 of 20
S
Instruments, Inc.
,
600 Young Street, Tonawanda, NY 14150
Tel: 716-693-5977 Fax: 716-693-5854 URL:
www.srscales.com
email:
Copyright 2013
S
Instruments, Inc.
ASSEMBLY Cont’d
STEP 6
: Attach the Display Cable Connector (6) to its mate in the Base Assembly. Slide the extra
cable back up into the mast pipe.
STEP 7
: Install the six (6) “D” cell batteries as indicated on the Battery Compartment Cover
label. Tightly close the cover.
STEP 8
: Return the scale to the upright position.
INSTALLING OPTIONAL PRINTER
STEP 1:
Mount the Printer Mast Bracket (8) to the rear of the Mast Assembly (1) using the two
(2) mounting screws provided.
NOTE:
The three holes on the Printer Mast Bracket should be
towards the top of the Mast (figure 3).
STEP 2:
Apply a small amount of Loctite
to the three (3) small screws provided and attach
the Printer Mounting Bracket to the Printer Mast Bracket (figure 4).
STEP 3:
Attach the Printer to the Printer Mounting Bracket by inserting the tabs on the Printer
Mounting Bracket (figure 4) into the slots on the back of the Printer and carefully snap in place.
STEP 4:
Plug the Printer Cable into the Printer and into the Display Unit. Tighten the connector
screws into the Display Unit connector.
Figure 3: Printer Mast Bracket
Figure 4: Printer Mounting Bracket
