Model SRV947IFS-BT 24 X 48 Remote Display Platform Scale
Operating and Service Manual
Part No.: MAN947IFSBT_190708
Page 4 of 14
S
Instruments, Inc.
,
600 Young Street, Tonawanda, NY 14150
Tel: 716-693-5977 Fax: 716-693-5854 URL:
email:
Copyright
2019
S
Instruments, Inc.
ASSEMBLY
STEP 1
: Unpack the scale system and check parts
against the
PACKING CHECKLIST
. If there are
any missing or damaged parts, please call the Service
Hotline at: 1-800-654-6360.
STEP 2
: Verify that the serial number on the label of
Wall Box Display matches that on Platform Base.
STEP 3
: (Figure 1) Mount Wall Box Display into
wall and run the conduit, with connector cable inside,
down through wall and into pit as shown.
STEP 4
: Prepare pit area to accept the Scale
Frame. It is recommended that a properly
plumbed drain be installed in the center of pit to
avoid any water buildup that might damage scale.
STEP 5
: Center the Scale Frame in the pit.
NOTE:
Scale frame dimensions are 52” x 28” x 2” deep. Recommended pit perimeter
dimensions are 58” x 34”.
STEP 6
:
(Figure 2) Back fill around the perimeter of the Pit Frame Assembly with 3000PSI concrete.
Trowel the concrete level with the scale frame and existing floor. Trowel the base of the pit level with
the base of the frame with a gradient toward the centered drain, if used. Conduit and cable should be left
free so cable can be easily connected to the Platform Assembly.
STEP 7
:
When the concrete has set, connect the Cable Assembly to
the mating connector on the Platform Assembly.
STEP 8
:
Carefully lower the Platform Assembly into the Pit Frame
Assembly. Ensure that Platform feet set into locators on Pit Frame and that
extra cable does not interfere with platform.
STEP 9:
Install building ground wire and green ground wire from Display Front Plate into the
terminal lug in the wall box
STEP 10:
Connect signal cable to the mating connector on the Display Front Panel
STEP 11:
Connect A/C power wires to the power supply wire leads
STEP 12:
Install Front Panel Assembly to the previously mounted Wall Box. Use supplied star
washers and screws. Ensure screws are securely tightened.
STEP 13:
Restore power to the display
Figure 1: Wall Box Assembly/Conduit
Placement
Figure 2: Concrete Fill