www.sraquaristik.com
User Manual
page 4 of 8
Advanced Control Panel Settings
Setting the Time
Press the plus and minus button for one second, use the pause button to switch from
hours to minutes. Use the plus and minus button to adjust time.
Control Panel Codes
Press the minus button for three seconds, this will give you the control panel/ pump
model number.
Press the pause button for five seconds to restore factory default settings.
Pump is overheating, something may be jammed in the impeller,
or the impeller needs to be cleaned.
Control panel failure, the control panel will need to be replaced.
Pump failure, the pump will need to be cleaned, pump intake
may be blocked. The pump is getting an unstable voltage.
Pump is in run dry mode, if the pump is not getting enough water
it will automatically shut off until enough water is present. The
pump will automatically restart and clear the error code.
Pump is overheating, this can because by restricted flow or
excessive head height.
Sensor fault
