1
The CXUL.XL is an Ultralight BASE harness/container system with integrated risers. It is imperative
that you take the time to learn the proper assembly, packing, and closing procedures before you
use this system. If you are unsure of any aspect of the assembly or use of this system, stop use
immediately and seek professional instruction. We recommend that you assemble and pack this
container system under the guidance/instruction of a qualified BASE instructor or parachute rigger.
THE SYSTEM
Common techniques used to pack other 2-pin container systems, which use a floor-plate closing
method for the top pin, will work for the CXUL.XL as well. Please keep these points in mind:
1.
We recommend placing your pull-up cord through the top closing loop before placing your canopy in the
container (easier to access once the parachute is covering the loop).
2.
You can place the tailpocket in the packing tray regular or inverse, high or low. However, the placement
shown here has proven to work well with this container.
PACKING TIPS
Your CXUL.XL is shipped with two sets of
closing loops. Install the shorter closing loop
into the bottom flap of your container, and the
top (longer) loop into the floor-plate inside the
container. Use the washers provided – they
must be placed between the grommet and the
knot. Note that the closing loops supplied with
your CXUL.XL are double-ended, and can be
reversed when one side begins to show wear.
CLOSING LOOPS
The CXUL.XL’s chest strap is made from 3000 lb. nylon webbing, and the non-
slip milled aluminum buckle is rated to over 14 kN. As a single component,
the chest strap is more than strong enough to support bodyweight. NEVER
rappel from your chest strap without the proper hardware, instruction, and
experience, and always back-up all weight-bearing systems.
The CXUL.XL harness geometry was carefully chosen to avoid peeling
loads at any angle, in particular at the integrated riser/MLW junction.
Each component of the harness has been load tested individually, as well
as the harness as a whole. The CXUL.XL’s integrated riser design was load
tested to >22 kN in every conceivable load direction.
The CXUL.XL webbing is a blend of Dyneema and polyester. The
Dyneema provides a high level of strength while the polyester provides
structure. Dyneema fiber is durable and more resistant to environmental
factors compared to classic nylon.
DYNEEMA BLEND WEBBING
CHEST STRAP
INTEGRATED RISERS
Содержание CXUL.XL
Страница 5: ...4...
