Using the Video Recording Feature
1. To turn on the camera and start recording, hold down
the button located on the top right of the watch. After
2 seconds, the steady blue light will blink 3 times and
then shut off. This indicates that the watch is now re-
cording.
2. To stop recording, double tap the same button on
the top right of the watch. The blue light will blink 3
times, indicating that recording has stopped and the
camera is now in standby mode.
3. To start recording again after step 2, double tap the
top right button and the camera will start recording.
Using the IR Feature
1. Begin by completing step 1 and 2 in the “Using the
Video Recording Feature” section above to get the
camera to enter standby mode.
2. Once in standby mode, you activate the IR feature by
holding down the button located on the top left until
the red light blinks three times. Note: To start record-
ing after turning on IR mode, just double tap the but-
ton located at the top right.
3. To deactivate IR mode, put the camera back into
standby mode and press the button located on the
top left. The blue light will flash three times, indicat-
ing that the IR feature is now deactivated.
