11
2
DELAy (IN Photo MoDE)
Allows the user to choose the time interval between each detection before
the camera records the next photo or video
*
.
Additional setting
: It is possible to decrease the delay between detections
to 10 seconds (instead of 1 minute) by using the following procedure. Note
that the battery life will be affected.
1. Turn OFF the camera.
2. Press and hold the UP button, turn the camera on. "10_S" appears on
the screen meaning the 1 minute delay has been replaced by a 10 second
delay.
3. To reset the camera to 1 minute delay, follow the same procedure. "1_M"
appears on the screen (see figure below).
DELAy (WIth tIME LAPSE oN)
Allows the camera to take photos at regular preset intervals without detec-
tion
(IRoN-10)
. The user can obtain photos of game outside the detection
range of the camera.
To set the Time-lapse option:
1. Turn the Time-Lapse option ON in the settings menu of the camera.
2. Set the switch panel in PHOTO mode, and choose the intervals with the
DELAY switch.
3. To go back to regular photo settings, turn OFF the Time Lapse option.
Note:
The TIME LAPSE mode only applies for photos, not videos.
3
MULtI-Shot
Takes up to 4 consecutive shots at each detection, with a 10 second delay
between each photo. For the cameras with a Flash unit, the delay between
each photo will be 15 seconds. This option allows the user to get up 4 photos
from different angles when the camera is in PHOTO mode.
4
vIDEo LENgth
Allows the user to select the duration of the recording when the camera is
set in VIDEO mode.
Settings
IRoN
10_5
10 s delay
1 min delay
Recommended settings
The camera can be configured for
usage in
trails
. This situation usually
presents low activity level, fast subjects and a small number of photos is
expected. These settings increase the chances of capturing animals that
follow each other.
The camera can also be configured for
usage at a feeder's site
. This
situation usually presents high activity level, slow subjects and a large
number of photos is expected. These settings moderate the number of
photos taken while capturing overall activity on feeder's site.
here is a table showing the suggested settings for each situation:
trail
feeder
Delay
1 min (or 10 sec)
5 min
Multi-shots
1
2-3
When these recommended settings are not adapted to the situation,
battery life can be affected.