1009510 Rev A
6
ASSEMBLY AND SET-UP
A. Assembly
1. Remove top and sides of shipping container.
2. Locate and remove literature pack from seed hopper.
3. Cut all nylon straps retaining machine to shipping
container.
4. Cut nylon strap holding blade engagement handle to
handlebar.
5. DO NOT CUT
the nylon straps that hold the control
cables to the handlebar.
Remove Pin
From Both
Sides
6. Remove hairpin and clevis pin (both sides) from handle
bar pivot and rotate handlebar into working position.
Re-Install The
Pin On Both
Sides
Pivot
7. Pivot control handle into position and re-install clevis
pin and hair pin both sides.
independent of the engine speed. Pulling the right lever
rearward increases the forward speed and pulling the left lever
rearward increases the reverse speed. Do not move both
levers in unison, only pull one at a time. To start the engine,
ensure both levers are in their neutral position. Forward
motion is variable based on where the lever is positioned in the
forward mode. To operate the unit in reverse, the reverse lever
must be held.
10. Seed Flow Lever:
Move the lever forward to open the seed plate allowing seeds
to fl ow through the openings. Move the lever to the rear to
stop seed fl ow. To close the hopper gate, place the handle in
locked position.
11. Seed Flow Metering Gauge:
Adjust seed fl ow by loosening the knob, rotating the dial stop to
the desired setting and then tightening the knob to lock. When
ready to drop seed, release handle from locked position and
push forward. See the seeding table underneath the lid of the
hopper for seeding rates.
12. Slicer Blade Control Lever:
When the lever is pulled back, the slicer blades rotate. To
disengage the slicer, release the lever. The lever must be
disengaged to start the engine. To prevent damage to the unit,
always lift the front wheels off the surface before engaging the
slicer control lever.