Enable Nite Cycle (OFF / ON)
To Enable/
Disable
the Nite Cycle
press the Enter button while on this display.
Nighttime Temperature:
This setting is the temperature the device will maintain during the Nite Cycle.
NiteCycle Start Time:
This setting adjusts what time the Nite Cycle starts.
(Output Setup for Temperature Control continued...)
NiteCycle End Time:
This setting adjusts what time the Nite Cycle
ends.
Ramping:
This setting adjusts how long it will take to switch between the DayTemp and NiteTemp
settings allowing a
smooth transition up to 10 hours.
High / Low Alarms Menu:
Enter this menu to set the audible High / Low Alarm feature.
Enable H/L Alarm (OFF / ON)
To Enable/
Disable the
High/Low Alarms press the Enter button while on this display.
High Temp Alarm:
This setting is the highest temperature at which the audible alarm triggers if breached.
Low Temp Alarm:
This setting is the lowest temperature at which the audible alarm triggers if breached.
Low Alarm 30 min Mute (OFF / ON)
This setting by default is disabled and is only available in temperature related modes. This will mute the low
temperature alarm for 30 minutes anytime the low alarm is triggered. This is useful to allow time for the
temperature to reach the target setting. If the Low Alarm is triggered you can reactivate the mute by entering
the menu or by pressing the PLUS button on the main display that shows the probe temperatures. This will
allow another 30 minutes before the Low Alarm becomes active again.
Sensor Adjustment:
The Sensor Adjustment setting is used to alter the temperature read by the temperature probe to match other
equipment.
Note: The sensor used in the Herpstat Probes are typically more accurate than most other
equipment. Adjustments to this setting are usually not necessary.
Temperature Swing:
This controls the range of temperature. In heating mode this is the amount of degrees it will allow to drop
below your Daytime or Nitetime
setting before turning the output back on. In cooling mode the temperature
must drop this amount below the Daytime Temperature or Nitetime Temperature setting temperature before the
output will be turned off.
Security Passcode
From the initial menu screen select Security Passcode using the Plus and Minus button and press Enter.
This setting creates a 4-digit Passcode that is required to be entered before menu access is granted. Use the
Plus and Minus buttons to toggle the individual digit and the Enter button to advance to the next digit. Entering
all zero's will disable the Passcode. If the menu timeout expires while in this setting the Passcode will be
disabled automatically. If you forget this Passcode in order to regain access to the menu requires the device to
be reset to factory defaults. This can be done by holding down the Plus button while plugging the Herpstat into
power. All settings are lost in the reset process.
