3
Camera Installation
Before you install the camera, carefully plan where and how it will be positioned, and where you will route
the cable that connects the camera to the power adaptor.
Before starting permanent installation, verify its performance by observing the image on the receiver when
camera is positioned in the same location/position where it will be permanently installed, and the receiver
is placed in the location where it will be used most of the time.
Installation Warnings
Aim the camera(s) to best optimize the viewing area. Select a location for the camera that provides a clear
view of the area you want to monitor, which is free from dust, and is not in line-of-sight to a strong light
source or direct sunlight.
Avoid installing the cameras where there are thick walls, or obstructions between the cameras and the
receiver.
Night Vision
This camera has built-in IR Cut Filter, which provides the camera with the ability to view images in no/low
light conditions.
Installing the Camera
1. Carefully unpack the camera
2. Pair the camera(s)
If the camera(s) did not come in the same box as the receiver, then you will need to pair the camera to the
monitor. Consult the Pairing section in the system manual on how to do this.
3. Mount the camera to the wall
Mark the position of the screw holes on the wall, and drill holes and insert 3
screws, then firmly attach the camera to the wall. Make sure to strongly secure
the screw the mounting bracket into the wall
NOTE: The camera can also be placed on a flat surface, such as a Table or Shelf,
and no mounting hardware is required.
3. Adjust the viewing angle of the camera
You can adjust camera angle to desired viewing area.
NOTE: You can install additional cameras (maximum of 4 cameras per receiver).
