SPX OTC 6980 Скачать руководство пользователя страница 2

Parts List & Operating Instructions 

OPERATION

1. Refer to the vehicle service manual for

instructions on using an appropriate
lifting device to hoist the vehicle off the
ground. Lift the vehicle just far enough
to remove the wheel and tire.

2. After removing the wheel, completely

thread two lug nuts back onto two
opposing wheel studs. Back off the lug
nuts three or four turns to allow the
drum to be pulled away from, but not fall
off, the wheel hub. See Figure 1.

3. Estimate the diameter of the brake

drum. Using the marks on the puller
crossbar as a guide, set the jaws an
equal distance apart from the center on
each side of the brake drum.

4. With the forcing screw at the center of

the wheel hub, position the puller jaws
in the groove between the brake drum
and the backing plate. Adjust the jaws

on the crossbar as needed to fit.

5. Verify the jaws have good contact with

the drum, and hand-tighten the forcing
screw to the wheel hub.

6. Place the strap (provided) over the

puller and brake drum. Position it
around the outer edge of the drum and
within the tabs of the jaws. Cinch the
strap tightly in place. See Figure 2.

7. Using a ratchet or impact wrench, turn

the forcing screw inward just enough to
remove the brake drum.

8. Remove the strap and the puller from

the brake drum. Remove the lug nuts
and remove the brake drum.

Lug nuts on 
opposing 
wheel studs

Verify the puller 
jaw has good 
contact with the 
brake drum.

Strap in 
position 
and cinched 
tightly in 
place.

Marks on
puller crossbar

 

WARNING: To prevent personal injury,

wear eye protection that meets ANSI Z87.1 and OSHA standards.

Figure 1

Figure 2

Feel the difference with OTC.

Discover other automotive tools on our website.

Отзывы: