5
Operation
CONTROL PANEL
Figure2
1.
Carefully remove all packaging materials.
2.
The heater must be placed on a flat level surface.
3.
Plug the cord set into a 120V
～
electrical outlet. Be sure plug fits
tightly in outlet. A loose fit will cause overheating and damage the
plug. Plug and cord set may feel warm during normal usage.
4.
Once heater is plugged in, unit will emit an audible beep. The power
light will illuminate and will remain lit until power is disconnected.
5.
Press the POWER/MODE button to start the heater. Unit will begin
operating in Low heat mode. Continue pressing the POWER/MODE
button will cycle through the modes: LOW
→
HIGH
→
AUTO
→
FAN.
LOW heat mode (900W). Indicators: “L” and “
” with bar
moving to mid-point.
HIGH heat mode (1500W). Indicators: “H” and “
” with bar
moving all the way to the right.
AUTO mode (1500W). Indicators: “A” and “
” with bar moving
all the way to the right. Notice that the LCD now displays a SET
TEMP indicator (see THERMOSTAT INSTRUCTION).
FAN mode (25W). Indicators: “F” and “
” with no bar. This
mode is fan-only operation, without any heat output.
