To stop operation, press 0 to turn off.
3
B
D
E
F
C
A
ig. 2
F
Fig. 3
Fasten
O
N
P
T
U
Fig. 1
Fig. 4
J
L
N
M
Q
O
OPERATING INSTRUCTION
1. Place the fan on a level surface. Plug into a standard 120V AC 3-Prong wall outlet.
2. Attach the Valve(S) to a standard outdoor hose. Turn on water at the spigot and use the lever on the
Valve(S) to turn water on and off.
4. Oscillation: push the Knob (G) down (on motor head) for fan oscillation or pull the knob up to xed direction.
5. Adjust the angle of the fan head by gently pushing upwards or downwards.
3. To operate, push the control button corresponding to the desire speed: 1 - low, 2 - medium, 3 - high.
6. The height of the fan can be adjusted by loosening the height adjustment Knob (O) and carefully adjusting the
Internal Pole(N). Secure by tightening the Height adjustment Knob(O). Always be sure the waterproof Cover(L)
covers the Height adjustable Knob(O) after adjusting the Internal Pole(N).
ASSEMBLY INSTRUCTIONS
Step 1. Fan Base Assembly (Fig. 1)
1. Unscrew the Screw (U) from the external Pole (P). Attach external Pole (P) to Base (T) and secure
the Screw(U) from beneath the base.
2. Remove the height adjustment Knob (O) by unscrewing it counterclockwise.
3. Use your nger to pull out the internal Pole(N) and slide height adjustment Knob (O) over internal Pole (N). Fasten
it to external Pole (P) by turning the knob while holding the pole. Make sure the Knob (O) is tightly fastened.
Step 2. Fan Head Assembly (Fig. 2)
1. Remove the blade Cap (B) by turning clockwise. Remove the plastic Nut(D) by turning counter clockwise.
2. Mount the rear Grille(E) to the motor Shaft(F). With the handle on top, match the notch on the rear Grille(E) to the
three prongs on the motor Housing(G).
3. Secure rear Grille(E) by turning the plastic Nut(D) clockwise and tighten rmly.
4. Slide the fan Blade(C) onto the motor shaft(F), with the hollow interior of the blade facing toward rear Grille.
5. Secure Fan Blade(C) by turning the blade Cap (B) counterclockwise and tighten rmly.
6. Loosen the bolt on the bottom of the Front Grille(A). Mount the Front Grille(A) with the logo right side up to the
Rear Grille(E), snap the two together. Start at the top and work your way around to ensure all snaps are secure.
7. Tighten the bolt on the bottom of the Front Grille(A).
Step 3. Final Assembly (Fig. 4)
1. Loosen the thumb Screw (J) by turning it counter clockwise.
2. Place Misting Line Holder(M) followed by the Water Proof Cover(L) onto the Internal Pole(N).
3. Insert the motor head assembly onto the Internal Pole(N). Secure by turning the Thumb Screw(J) clockwise.
Note: Always keep the Height Adjustment Knob(O) covered by the Waterproof Cover(L) when adjusting the height.
Be sure it is tight enough to support the fan head.
4.Secure the Misting Line(Q) to the clip under the Front Grille(A) then to the Misting Line Holder(M).
