SPRT
®
SP-TL31Thermal Label Printer User’s Manual
8
Self-test prints out parameters in fellow order: manufacturer name, printer model, software
version, interface type, default value of printer parameters, 96 characters in ASSIC code, default code
page content (language setting is English) or Chinese character library name ( The language is set to
Chinese) and the barcode type. Note: gap sensor related parameter included under label mode.
3.2.3 Paper feed (manual paper feed)
Receipt paper mode: In the power-on state, put in the ordinary thermal paper, press the
【
FEED
】
button, the printer starts to feed the paper, release the
【
FEED
】
button to stop the paper feeding;
Label mode: In the power-on state, put in the thermal label paper, press the
【
FEED
】
key. The
printer forwards the paper to find the label gap, and sends the label gap to the tear line position.
3.2.4 Paper auto feeding
Adjust the paper width limit block to a suitable position. When the printer is turned on and the
paper house cover is closed, feed the paper into the printer from the paper inlet, and the printer will
automatically suck the paper in.
3.2.5 The first order zero waste
In the power-on state, the printer will automatically perform the first order zero waste function after
the printer is powered on, cover opened and closed, and automatically loaded paper, to ensure that
the printing paper is not wasted.
3.2.6 Hexadecimal printing
Follow the steps below to turn the printer into hex print mode.
1. Open the paper cover;
2. Press the
【
FEED
】
button to turn on the power. Wait for the power indicator and the error
indicator to flash alternately, then close the paper cover.
3. At this point, the following 3 lines of content are printed:
Hexadecimal Dump
To terminate hexadecimal dump,
Press FEED button three times.
It indicates that the printer enters hex mode. In this mode, all inputs will be printed as hexadecimal
numbers. Each press of the
【
FEED
】
key will feed a line of paper. Press 3 times in total, and it will print
out "*** Completed * **", which means exit hex print mode.
3.2.7 Printer parameter settings
There are two ways to set printer parameters:
1. Use the setting tool on PC to set.
2. Set by button, the specific operation methods are as follows:
In the power off state, open the Paper Cover firstly, press the
【
FEED
】
button, then turn on the
power. Release the
【
FEED
】
button after the power indicator and error indicator flash alternately.
Press the
【
FEED
】
button two times, then close the Paper Cover. The printer enters the parameter
setting mode and prints out the first settable parameter and its current set value. Check Appendix A for
