default IP address of printer (192.168.1.114); otherwise, pls use the normal
working IP address (Printed IP address on self-test receipt).
The method of entering upgrading mode:
When the printer is off, open paper case cover firstly, hold down
【
FEED
】
button and turn on the printer power. After the status indicator and PAPER
OUT indicator flicker alternately, loosen
【
FEED
】
button. Then press
【
FEED
】
button five times and close the paper case cover. The printer enters into
Software Upgrading Mode. In this case, the indicator flickers once a second.
The method of quick entering: When the printer is off, open paper case cover
firstly, hold down
【
FEED
】
button and turn on the printer power. Then loosen
【
FEED
】
button quickly. The printer enters into Software Upgrading Mode. In
this case, the indicator flickers once a second.
Caution:
the software can be upgraded online only through Ethernet or USB
interface.
2.6.4 Recovering Default IP Address
If the IP address of printer is set to be invalid IP address, the printer will be not
able to normally working through Ethernet interface. In this case, it will need to
recover default IP address.
The method of recovering default IP address: When the printer is off, open
paper case cover firstly, hold down
【
FEED
】
button and turn on the printer
power. After the status indicator and PAPER OUT indicator flicker alternately,
loosen
【
FEED
】
button. Then press
【
FEED
】
button four times and close the
paper case cover. The printer will print out the default IP address parameters.
2.7 Wall-mounted Installation
1. Install two wall-mounted buckles to the back side of priner by screws, as
showed in Picture2.10,
Picture2.10
2. Install the wall-mounted board to the wall by screws. And hang the printer
PDF created with pdfFactory trial version
