Page 27
o
Static sensitive components inside - do not remove the lid or base: No user serviceable parts
inside.
o
Position the power cord to avoid possible damage; do not overload circuits.
o
Do not place this product on or near a direct heat source and avoid placing objects on the
terminal.
o
Use only a damp cloth for cleaning. Do not use liquid or aerosol cleaners. Disconnect the
power before cleaning.
o
It is the user’s responsibility to install this device in accordance with the local electrical codes.
o
Installation of the Sprint TREBL unit should be performed by someone familiar with the
product.
o
The circuit breaker where connected should be easily accessible in case you have to
disconnect the device.
o
When installed in the final configuration, the product must comply with the applicable Safety
Standards and regulatory requirements of the country in which it is installed. If necessary,
consult with the appropriate regulatory agencies and inspection authorities to ensure
compliance.
7.7 Service Information
Refer all repairs to qualified service personnel. Do not modify any part of this device, as this will void
the warranty.
Disconnect the power to this product and return it for service if the following conditions apply:
a. The unit does not function after following the operating instructions outlined in this manual.
b. The product has been dropped or the housing is damaged.
Locate the serial number of the terminal and record this on your registration card for future reference.
Also record the MAC address, located on the product sticker.
7.8 UL Information
- The circuit where the equipment is connected must be properly grounded according with NEC and
other local safety code requirements.
- Reminder to all the BWA system installers: Attention to Section 820-40 of the NEC which provides
guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected
to the grounding system of the building, as close to the point of cable entry as is practical.
