Section 2
4
Turning Your Phone ON and OFF
Section 3
Using the Battery and Charger
5
Turning Your Phone
On and Off
Turning Your Phone ON
1.
Fully extend the antenna to receive the best reception.
2.
Press
for two seconds. The phone will display “Searching
for Service” until it locates a signal, then it will automatically
enter Standby mode – the phone’s idle state. At this point,
you’re ready to begin making and receiving calls.
Turning Your Phone OFF
Press
for two seconds until the screen displays its
powering off message (for example, “LG Goodbye!”).
PWR
END
PWR
END
Using the Battery and
Charger
Installing and Removing the Battery
To install, insert the battery into the opening on the back of the
phone and gently press down until the latch snaps into place.
To remove, make sure the power is off. Press the battery release
latch up and remove the battery from the phone at a
45-degree angle.
Charging the Battery
It is vital that you use only Sprint PCS-approved Desktop Chargers
and AC Adapter Chargers. Use of unauthorized accessories could
damage your phone and invalidate your warranty.
To use the desktop charger provided with your phone:
1.
Plug the round end of the AC adapter into the charger holder
and the other end into the electrical outlet.
2.
Insert the phone (with battery installed) into the slot.
A red light on the charger lets you know the battery
is charging.
A green light lets you know the battery is at least
80 percent charged.
It takes about three hours to fully recharge a completely
rundown battery.
