Sprint Electric 1600i, Руководство по эксплуатации продукта

Страница: 22 / 24

16 Specifications
Function Specification
Comments
CONTROL ACTION DUAL LOOP PROPOR INTEGRAL
FEEDBACK METHOD ARMATURE VOLTS TACHOMETER SWITCH SELECTABLE
0-100% REGULATION 2% TYPICAL 0.1% TYPICAL
BEWARE MOTOR HEAT
AT LOW SPEED
MAX TORQUE SPEED RANGE 20 : 1 100 : 1
OVERLOAD 150% CONTINUOUS CURRENT FOR 30 SECONDS
Customer Presets
MAX SPEED 25 - 400 V FULL SCALE FEEDBACK SWITCH SELECTABLE
MIN SPEED 0-30% OF MAX SPEED NON-INTERACTIVE
UP/DOWN RAMPS INDEPENDENTLY ADJUSTABLE 1-30 SECONDS LINEAR RAMPS
STABILITY VARIES SPEED LOOP GAIN
IR COMPENSATION 0-30% OF ARMATURE VOLTAGE DO NOT USE WITH TACHO
MAX CURRENT LINEAR SETTING FROM 0-100%, 4 SWITCHED RANGES 150% OVERLOAD
Switch Selectable
CURRENT RANGE FOUR RANGES OF ARMATURE CURRENT S1, S2
SPEED RANGE FOUR RANGES OF FEEDBACK VOLTAGE S3, S4
RELAY FUNCTION DRIVE STALL OR ZERO SPEED RELAY S5, S6
POWER UP HOLD POWER UP INSTALL OR RUN MODE S7
TACHO/AVF SELECT TACHO OR ARMATURE VOLTAGE FEEDBACK S8
Jumper Functions
TORQUE MODE 0-10 V INPUT FOR 0-100% CURRENT WITH AUTOMATIC
OVERSPEED PROTECTION
JUMPER SELECTABLE
SUPPLY SELECT DUAL SUPPLY VOLTAGE SELECTOR JUMPER SELECTABLE
Link Functions
4-20 mA OR 0-20 mA LOOP ALLOWS CURRENT LOOP SIGNAL INPUT FOR SPEED 5 V COMPLIANCE
50% STALL LEVEL ALLOWS LARGE PEAK CURRENTS 150% PEAK
SUPPLY RANGES LV30 LV60 110 240 415
OVER FULL TEMP RANGE WITH
OUTPUTS LOADED
45 Hz to 65 Hz MAX 36 V 72 V 130 V 264 V 440 V
AUTO RANGING MIN 27 V 54 V 100 V 200 V 360 V
AC POWER RESET MINIMUM OFF TIME BEFORE RE-SUPPLY 500 ms
RUN LINE 60 ms ON, 20 ms OFF. ALWAYS USE A RUN CONTACT TO
ENABLE THE DRIVE AFTER THE APPLICATION OF AC
SIGNAL OUTPUTS SPEED, CURRENT, RAMP, DEMAND ALL BUFFERED
SIGNAL INPUTS 3 SPEED INPUTS -/+ RAMPED, DIRECT, ALL SUMMING PROTECTED
RELAY OUTPUTS STALL OR ZERO SPEED RELAY VOLT-FREE CHANGEOVER
RELAY DRIVERS STALL, ZERO SPEED OPEN COLLECTOR PNP FOR -24 Vdc 100 mA MAX
RAIL OUTPUTS -24 V UNREGULATED 10 mA +/- 20%
+12 V, +10 V, -12 V REGULATED 10 mA 0.01%/DEG C 5%
FIELD OUTPUT 0.9 (0.45) x AC SUPPLY. 1600i 1 A, 3200i 2 A. FULL (0.9) OR HALF WAVE (0.45)
IP RATING IP00
ALTITUDE 3000 METRES MAX FOR FULL RATING DE-RATE 1%/100m
HUMIDITY 85% R.H AT 40ºC, NON-CONDENSING
FORM FACTOR TYPICAL 1.5 AT MAX OUTPUT
TEMPERATURE STORAGE AND OPERATING -10 TO + 50ºC
ARMATURE TIME CONSTANT MINIMUM 10 ms. USE EXTRA ARMATURE CHOKE TO
INCREASE
T= INDUCTANCE/RESISTANCE
MAX I
2
t FUSING
(Amps
2
Seconds)
1600i = 365
3200i/8 = 365, 3200i/16 = 555, 3200i/32 = 940,
3200i/48 = 4750
SEMICONDUCTOR FUSES
Refer to page 2
6 6 Specifications Specifications