7
Carbon Rinse Instructions
1.
After the carbon has soaked for 2 days take the bypass valve out of
bypass into the service mode.
2.
Locate the hose bib assembly and connect it to the Inlet side. Connect
a water hose to the opposite end of the hose bib assembly.
3.
Turn the water on slowly and only halfway on and allow the water to run
for 15-20 minutes.
4.
Turn water off and disconnect the water hose.
5.
Connect water the hose to outlet side and turn the water on slowly to
full strength.
6.
Allow water to run for 5 minutes.
7.
Disconnect the hose and connect to the inlet side.
8.
Turn water on slowly halfway, run for 10 minutes.
9.
Disconnect the hose bib assembly.
Note:
At this point all of the carbon dust should
be completely out of the carbon bed. However,
there can be some residual dust which you will
sometimes see in toilets and toilet tanks. This is
completely normal and should clear within a
day or two.
