SPRIANO SST7 Series, Руководство по эксплуатации

Страница: 40 / 52

OPERATING MANUAL
MN-SST70
ED-19-01
SPRIANO® TECHNOLOGIES
- www.spriano.it – spriano@terranova-instruments.com
a TERRANOVA® Srl brand
- www.terranova-instruments.com - VAT IT07848810151
Factory & Sales: Via Gramsci 1 – 26827 Terranova dei Passerini (LO) – Italy
Head Office: Via Rosso Medardo 16 – 20159 Milano – Italy Ph: +39 0377 919119 – Fax: +39 0377 855720
Pa
g.
40
/52
Step 3 ( Figure 26 ):
Eliminate the zero offset introduced by Step 1 ( Figure 24 ) and Step 2 ( Figure 25 ) as follow:

if the zero offset is >±4% there are two ways to operate:
o
if the offset has a positive value (Ex. +6%):

you might loosen the nut (N) with a wrench CH.6;

Rotate the screw (M) from left to right using a wrench CH.7;

When the offset reaches a value of ±1% then stop rotating the screw (M) and fix
the nut (N);

Eliminate now the remaining offset with the relative function from the
configuration menu (Cfr manual section Keyboard Configuration).
o
if the offset has a negative value (Ex. -6%):
 you might loosen the nut (N) with a wrench CH.6;

rotate the screw (M) from right to left using a wrench CH.7;

When the offset reaches a value of ±1% then stop rotating the screw (M) and fix
the nut (N);

Eliminate now the remaining offset with the relative function (Cfr manual
section Keyboard Configuration).
Figure 26: displacer substitution – Step 3
M
N