SPRIANO SPRIANO Series, Руководство по эксплуатации

Страница: 36 / 48

OPERATING MANUAL
MN-SST50
ED-17-09
SPRIANO® TECHNOLOGIES
- www.spriano.it – spriano@terranova-instruments.com
a TERRANOVA® Srl brand
- www.terranova-instruments.com - VAT IT07848810151
Factory & Sales: Via Gramsci 1 – 26827 Terranova dei Passerini (LO) – Italy
Head Office: Via Rosso Medardo 16 – 20159 Milano – Italy Ph: +39 0377 919119 – Fax: +39 0377 855720
Pa
g.
36
/4
8
Step 3 ( Figure 25 ):
Eliminate the zero offset introduced by Step 1 ( Figure 23 ) and Step 2 ( Figure 24 ) as follow:

if the zero offset is ≤±4% then you can use the OFFSET function from the configuration
menu (Cfr manual section Keyboard Configuration) to set the zero value.

if the zero offset is >±4% there are two ways to operate:
o
if the offset has a positive value (Ex. +6%) then you might loosen the nut N with a
wrench CH.6 and rotate the screw M from left to right using a wrench CH.7. When
the offset reaches a value of ±1% then stop rotating the screw M and fix the nut N.
Eliminate now the remaining offset with the relative function from the
configuration menu (Cfr manual section Keyboard Configuration).
o
if the offset has a negative value (Ex. -6%) then you might loosen the nut N with a
wrench CH.6 and rotate the screw M from right to left using a wrench CH.7. When
the offset reaches a value of ±1% then stop rotating the screw M and fix the nut N.
Eliminate now the remaining offset with the relative function (Cfr manual section
Keyboard Configuration).
Figure 25: displacer substitution – Step 3
M
N