Sprayit SP-33500, Инструкция по эксплуатации, Страница: 3 / 8

- 3 -
5.Use clean, dry and regulate compressed air rated at 2.0~3.5bar, never exceed maximum permissive
operating pressure (see fig 4)
6.Never use homogenate hydrocarbon solvent, which can chemically react with
aluminum and zinc parts and chemically compatible with aluminum and zinc pats.
7.Never point gun at you and others at any time.
8.Before operating the tool, make sure all the screws & caps are securely tightened
in case of leaking;
9. Before painting, make inspection for free movement of trigger and nozzle to insure tool can operate
properly.
10.Never modify this tool for any applications. Only use parts, nozzles and accessories recommended by
manufacture.

Instructions For Operation
Preparation
1. After unpacking the product, inspect carefully for any damage that may have occurred during transit.
Make sure to tighten fittings, bolts, etc., before putting unit into service.
2. Thoroughly mix and thin paint in accordance with the paint manufacturer
’s instructions.
Most materials will spray readily if thinned properly.
3. Strain material through filter, cheese cloth or a paint strainer.
4. Fill the canister about ¾ full and start the air compressor.
WARNING
DO NOT EXCEED MAXIMUM PRESSURE.
5. Connect the gun to air supply and please make sure that the fluid cap, container and air hose have
been connected tightly with spray gun.
6. Set up a piece of cardboard or other scrap material to use as a target and adjust for best spray
pattern.
WARNING
Never aim or spray at yourself or anybody else which would cause serious injury.
7. Test the consistency of the material by making a few strokes on a cardboard target. If material still
appears too thick, add a small amount of thinner. THIN WITH CARE! Do not exceed paint
manufacturer
’s thinning recommendations.
Adjustment
The desired pattern, volume of fluid output and fine atomization can easily be obtained by
regulating the Pattern Adjusting Knob, Fluid Adjusting Knob and Air Adjusting Knob.
PATTERN ADJUSTMENT: Turning Pattern Adjusting Knob
to the right until tight will make spray pattern round, or
turning left make spray pattern ellipse.
Material (PAINT) ADJUSTMENT: Turn the Paint Adjusting
Knob clockwise will decrease the volume of fluid output and
counter-clockwise will increase fluid output.
AIR Inlet ADJUSTMENT: Turning the Air Adjusting valve
clockwise will decrease the air volume.
And counter-clockwise will increase the air volume.
4