- 3 -
3. Important Safety Instructions
1. Toxic vapors produced by spraying certain materials can create intoxication
and serious damage to your health. Always wear safety glasses, gloves and
respirator to prevent toxic vapor hazard and solvent coming into contact with
your noise, eyes or skin. (See fig 1)
2. Never use oxygen, combustible or any other bottle gas as a power source. This
would cause explosion and serious personal injury. (See fig 2)
3. Fluid and solvent can be highly flammable or combustible.
Use in well-ventilated spray booth and avoid any ignition sources, such as
smoking, open flames and decrial hazard. (See fig 3)
4. Disconnect tool from air supply hose before doing tool maintenance and during
non-operation.
5. Use clean, dry and regulate compressed air rated at 2.0~3.5bar, never exceed
maximum permissive operating pressure
(see fig 4)
6. Never use homogenate hydrocarbon solvent, which can chemically react with
aluminum and zinc parts and chemically compatible with aluminum and zinc pats.
7. Never point gun at you and others at any time.
8. Before operating the tool, make sure all the screws & caps are securely tightened
in case of leaking;
9. Before painting, inspect for free movement of the trigger and nozzle to insure tool can operate well.
10. Never modify this tool for any applications. Only use parts, nozzles and accessories recommended
and accessories recommended by manufacture. This will void warranty.
11. This equipment should only be used in a well ventilated area.
4. Instructions For Operation
Preparation
1. After unpacking the product, inspect carefully for any damage that may have occurred during transit.
Make sure to tighten fittings, bolts, etc., before putting unit into service.
2. Thoroughly mix and thin paint in accordance with the paint manufacturer
’s instructions. Most
materials will spray readily if thinned properly.
3. Strain material through filter, cheese cloth or a paint strainer.
4. Fill the canister about ¾ full and start the air compressor.
WARNING
DO NOT EXCEED Spray Gun or any other parts in the compressor system MAXIMUM PRESSURE.
5. After Connect the gun to air supply, please make sure that the fluid cap, container and air hose have
been connected tightly with spray gun.
6. Set up a piece of cardboard or other scrap material to use as a
target and adjust for best spray pattern.
WARNING
Never aim or spray at yourself or anybody else which
would cause serious injury.
7. Test the consistency of the material by making a few strokes
on a cardboard target. If material still appears too thick, add a
small amount of thinner. THIN WITH CARE! Do not exceed
paint manufacturer
’s thinning recommendations.
1
图表
1
2
3
4
