INSTALLATION
• The TJ9 can be installed in any orientation.
• Use teflon tape when installing the TJ9.
• Screw the TJ9 onto a (model A: 3/8" NPT, model B: 1/2" NPT,
model C: 3/4" NPT) pipe to 150 in/lbs.
Item No.
Description
TJ9_-_ TankJet Qty.
Repl.
1
Snap Ring
1
•
2
Washer
1
•
3
Bearing
2
•
4
Barrel
1
5
Stem
1
For ABCKTJ9 - A repair kit (includes all items marked with (
•
)).
For ABCKTJ9 - B repair kit (includes all items marked with (
•
)).
For ABCKTJ9 - C repair kit (includes all items marked with (
•
)).
TROUBLE SHOOTING
Due to the simplicity of the unit, few problems should occur.
If any trouble should arise, the following steps may be taken:
Refer to the Parts List.
Problem:
Unit will not turn or turns slowly...
Solution:
1. Check for barrel end play (See Assembly Step #7)
2. Dissassemble unit and check for debris or
obstructions.
SERVICING
DISASSEMBLY:
1.
Remove (1) spiral retaining ring with a scribe or small
screwdriver.
2. Turn unit over to remove(2) washer.
3. To remove uppper (3) and (4) barrel, grasp barrel and
exposed portion of (5) and pull apart. Upper (3) bearing and
(4) barrel will separate from lower (3) bearing and (5) stem.
4. Slide lower (3) bearing off the (5) stem.
5. When disassembled, there will be six parts.
NOTE: There is no difference between "upper" and "lower"
(3) bearings. Parts are interchangeable...
ASSEMBLY:
1.
Place (5) stem on even surface...
2. Slide lower (3) bearing down onto (5) stem. Bearing flange
must seat down on stem face.
3. Place (4) barrel down over (5) stem and lower (3) bearing.
It will make no difference in performance which way the
barrel spins. Therefore, the barrel can go on over the stem
either way. Make sure barrel spins freely.
4. Push upper (3) bearing down over stem until the flange seat
into top of (4) barrel. Snap ring groove should be visible.
5. Push upper (2) washer on top of (3) bearing and (5) stem.
Snap ring groove should be visible. If not, push down on
washer until seated.
6. Using a scribe or small screwdriver, assemble (1) spiral
retaining ring into groove on top of stem.
Very Important: To set barrel end play, grasp barrel and
exposed portion of stem and pull apart. A click will indicate
end play adjustment. Spin barrel by hand to check for end
play and free spin of barrel. Repeat if necessary.
WARRANTY
For newly purchased units the warranty is 18 months
from the date of shipment or 12 months from the date of
installation, whichever occurs first. This warranty includes
manufacturing defects but does not cover the wear parts
that include the bushings. This warranty will be void if parts
other than those supplied by Spraying System Co. are used.
5
1
2
3
3
4
TJ 9 PART LIST
3
spray.com | 1.800.95.SPRAY | Intl. Tel: 1.630.665.5000
