3
SECTION 1
PREFACE
1.1 IMPORTANT
This AutoJet
®
VC10 Heated Spray Control System and all components are produced and checked at the factory. The
system can be dangerous if used incorrectly. Read this manual carefully and read all safety instructions.
Operators must always follow the general safety instructions in the working area and aim to prevent accidents.
The manufacturer reserves the right to make changes in standard construction without prior notification.
Images and diagrams in this manual may not be exact representations of your system configuration.
1.2 HOW TO USE THIS MANUAL
This manual is intended to be a source of information for the operators and technicians who may be installing, inter-
acting with, or servicing/maintaining Spraying Systems Co.
®
systems and components.
This manual contains important safety warnings, installation/operating instructions, troubleshooting and mainte-
nance information.
ICONS
WARNING: The user can be seriously injured, damage their health, and/or damage the system.
CAUTION: Product, process, or environment can be damaged or be in danger if the instructions are
not followed correctly.
ATTENTION: Supplementary information for the user that draws attention to possible problems.
SECTION 2
SAFETY
2.1 GENERAL SAFETY INFORMATION
READ AND FOLLOW INSTRUCTIONS
All safety
-
related and operating instructions should be read before the system is operated. Follow all operating instruc-
tions.
SERVICING
Do not attempt to service this system unless you have been trained or authorized to conduct repairs. Only authorized
and qualified service personnel should attempt to service this system. Service by unauthorized personnel may void any
and all warranties.
WARNING: Before performing any maintenance, make sure electrical power is off and any air/liquid
pressure is bled from the system.
UNINTENDED USE
Use of Spraying Systems Co.
®
equipment in ways other than those described in the documentation supplied with the
equipment may result in injury to persons or damage to property. Examples of unintended use of equipment would
be:
•
Using incompatible materials/damaged parts
•
Making unauthorized modifications/using unapproved auxiliary equipment
•
Removing or bypassing safety guards or interlocks
•
Operating equipment in excess of maximum ratings
