Sprayers Plus FH25E, Инструкция по эксплуатации

Страница: 11 / 12

If sprayer is not working as expected, consider the following table before contacting technial assistance.
12. Troubleshooting
Fault Status
Pump is working, but
fluid is not coming
out of the sprayer
Pump is not working
(no audible noise from pump)
while sprayer is turned ON
Spray pressure is weak
Spraying was normal
but stopped suddenly
Battery duration time is
shorter than usual or
battery failed to charge
－
Trigger valve is not released Trigger valve is shut Release trigger valve
Pump suction inside the
chemical tank is blocked
Contact for technical assistance
Suction hose is blocked
or disconnected
Pump or hoses are leaking
Nozzle or nozzle filter is blocked Clean or replace nozzle/filter
Trigger valve is released
Cause Solution
Trigger valve is not released Trigger valve is shut Release trigger valve
ON/OFF was pressed
No audible noise when pumping
Used battery with more than
300 charge cycles
New Battery
Pump reached maximum pressure
and pressure switch activated
Pump wiring is loose,
damaged or disconnected
Nozzle is plugged.
Rinse with clean water.
Charge the battery until indication
light on the charger turns green
Check pump wiring
Use Sprayers Plus certified charger
Use Sprayers Plus certified pump
Replace with new charger
Replace with new battery
Pump electrical connector
is disconnected
Nozzle or nozzle filter is blocked
Pump wiring is broken
Pump is damaged
Battery is fully discharged
Recharge battery with
Sprayers Plus charger
Place the lance with the trigger
valve pressed above the base of
the sprayer until the spray jey
begins to spray continuously
Battery is damaged and/or
electronic module is damaged
Connect pump electrical connector
Clean or replace nozzle/filter
Contact for technical assistance
Contact for technical assistance
Remove obstruction and circulate
clean water to clean the hoses
Circulate clean water to clean hoses
Contact for technical assistance
Clean or replace nozzle/filter
Trigger valve is released
Air accumulation inside the lance
Pump suction inside the chemical
tank is partially blocked
Suction hose is partially blocked
Battery is not fully charged
Using third-party charger
Using third-party pump
Damaged cords/plugs on charger
Battery is damaged. (e.g. became
wet, cracked, broken terminal)
Battery has exceeded its
optimal number of charge cycles
Pump or hoses are leaking
Nozzle or nozzle filter is
blocked or damaged
P.10