IV - CHANGING THE LAMP
2
Your projector has been designed for a maximum
voltage of 230 V.
The power cable complies with standards CEI 20-22.
However one must make sure that the ground is always
connected
.
Using the side handle 4 it is possible to release the
projector when it is locked in a certain position and
change its inclination. The same can be done as
regards its rotation with respect to the vertical axis by
loosening wing nut 9. The zoom is adjusted with levers
10, by widening or narrowing the beam of light. The
beam of light can be cut with the four flaps 11 to obtain
special effects.
VII - CLEANING
VI - FOCUS AND REGULATIONS
VIII - MAINTENANCE
The projector must be serviced at least once a year to
check the integrity of its electrical and mechanical parts.
. .
V - ELETTRICAL CONNECTIONS
For safety reasons always disconnect the projector
from the mains before opening it to change the lamp.
Open the projector latch by using knob 5. Insert the
lamp into the socket taking care not to touch the glass.
Since the new lamp may have a different centre of light,
it may be centred with knob 7 and the 2 screws 13.
For utmost projector performance, both the lens and
the reflector must be kept as clean as possible. To do
so, after disconnecting the projector from the mains,
open it and clean both the lens and reflector with a soft
cloth dampened with alcohol.
Followspot/steel
Line
Mod.PIC HS
