With your SPot Satellite GPS meSSenGer
What you neeD:
- Messenger
- 3 AAA Lithium Batteries (included)
- User’s Guide
at finDmeSPot.com
What you neeD:
- Personal information
- Emergency Contact information
- SMS (Text) and e-mail contacts for messaging
- Credit card information
- SPOT electronic serial number (ESN) and
authorization code. These codes are located
inside the battery compartment.
initial SyStem teSt:
Perform an initial system test to evaluate your entire
messaging system, from the operational condition of
the SPOT to the readiness of those you’ve chosen to
receive your messages.
1)
Go outside to where SPOT has a clear view of the
sky in all directions.
2)
Press and hold the ON/OFF button until the indicator
light blinks green.
3)
Press and hold the Check OK button until the
indicator light blinks green.
4)
Leave SPOT outdoors. The GPS indicator light blinks
green as SPOT acquires a GPS fix, then the
Message Sending indicator light will blink green
as SPOT transmits the Check OK message over the
20 minute message cycle.
5)
Verify that the message was received in the email
or SMS account(s) that you set up during activation
in your Check OK contact list.
With your SPot Satellite GPS meSSenGer
at finDmeSPot.com
SPOT activation requires a combination of hardware and online steps, outlined below.
Complete all steps in each row before moving on.
inStall the incluDeD batterieS:
1)
Loosen 2 screws holding the battery cover in place
2)
Write down the ESN and Authorization code for use
during service activation.
3)
Install AAA lithium batteries as shown
4)
Replace cover, then tighten screws with a
screwdriver or coin. It is important that you tighten
the battery cover to keep SPOT waterproof.
account SetuP:
1)
Log onto www.findmespot.com, choose your
country or language, and select the SPOT Account
tab. Click the Activate link.
2)
Follow the online instructions to choose a service
plan and activate your SPOT.
3)
Select additional services, such as Track Progress.
4)
When entering contact information, add your own
email or phone number to the Check OK contact list
for use in the system test.
SeRvice acTivaTiOn
If the GPS light blinks red, SPOT does not have a clear view of the GPS satellites and you must move to an area
with a clearer view of the sky for proper operation. Then repeat steps 2 through 5. You can update the names and
contact information anytime via your account on the SPOT website. Leave your personal contact information as
one of the contacts for future system testing and GPS Acquisition before each trip.
