7
17
20
1
16
6
1
18
21
15
5
4
22
12
*IMPORTANT*
*IMPORTANT*
*IMPORTANT*
*IMPORTANT*
two bolt connections. In many situations only one bolt is required.
remove any sharp edges. Go over entire unit to file smooth any sharp
(Details Continued
(Details Continued
(Details Continued
(Details Continued
7
Detail D
17
Detail G
Detail E
in shipping or installation. T-Clamps are designed for both one and
edges or projections that may have been caused by rough handling
Detail F
1
10
16
23
24
2
11
20
From Sheet 1)
From Sheet 1)
From Sheet 1)
From Sheet 1)
and/or replace immediately.
GENERAL MAINTENANCE INSTRUCITONS:
GENERAL MAINTENANCE INSTRUCITONS:
GENERAL MAINTENANCE INSTRUCITONS:
GENERAL MAINTENANCE INSTRUCITONS:
install 1 - 2 degrees off level to facilitate water drainage.
See specific assembly instructions. On products with platforms
include "A Handbook For Public Playground Safety". You can receive
under all playground equipment. Appropriate publications, available
GENERAL ASSEMBLY INSTRUCTIONS:
GENERAL ASSEMBLY INSTRUCTIONS:
GENERAL ASSEMBLY INSTRUCTIONS:
GENERAL ASSEMBLY INSTRUCTIONS:
your free copy by calling 1-301-504-0580.
of equipment and safety of users. Resilient Surfacing should be used
at NO Charge, from the consumer product Safety Commission,
and/or replacement of damaged parts is necessary for safe operation
cause serious injury. Periodical inspections, maintenance, repair
properly. Playground equipment which is improperly maintained can
prevent direct Sun on Slide's Chute.
NOTE: Slide should be installed in shaded areas or face NORTH to
Check MONTHLY for loose bolts, damaged or broken parts. Tighten
SPECIFIC ASSEMBLY INSTRUCTIONS:
SPECIFIC ASSEMBLY INSTRUCTIONS:
SPECIFIC ASSEMBLY INSTRUCTIONS:
SPECIFIC ASSEMBLY INSTRUCTIONS:
Please retain this instruction sheets in your files. It contains important
replacement parts information. All equipment should be installed in
accordance with these instructions.
It is important to use and maintain all public playground equipment
Check all the parts and hardware with the packing list to be sure you
have received everything needed to assemble this product. Contact
Your Local Distributor with notification of any missing or damaged
parts. Contact must be make within 10 days of receipt of your order.
Only hand-tighten nuts & bolts on initial assembly. Final tightening
should be done EVENLY after final assembly when unit has been
plumbed & leveled. After assembly is complete, any ends of bolts
protruding beyond nuts should be cut off and/or peened over to
NOTE: All threaded ends of bolts protruding beyond nuts must be
cut off and/or peened to eliminate sharp edges. NO more
than two threads should extend beyond face of nut.
All washers, "T" nuts, and other fastener hardware used on
round pipe or tubing must be hammered down to conform to
the curved underlying surface to eliminate catch points.
2
1
JR SLIDER
JR SLIDER
JR SLIDER
JR SLIDER
5
4
3
311-145
311-145
311-145
311-145
Sheet 2 of 3
Sheet 2 of 3
Sheet 2 of 3
Sheet 2 of 3
