Sheet 2 of 2
5
4
3
2
1
SINGLE SIDE BIKE RACK
802-175
GENERAL ASSEMBLY INSTRUCTIONS:
Check all the parts and hardware with the packing list to be sure you
have received everything needed to assemble this product.
CONTACT YOUR LOCAL DISTRIBUTOR OR SPORTSPLAY
EQUIPMENT WITH NOTIFICATION OF ANY MISSING OR
DAMAGED PARTS. Contact must be made within ten days of
receipt of your order.
Only hand tighten nuts & bolts on initial assembly. Final tightening
should be done EVENLY after final assembly when unit has been
plumbed & leveled.
After assembly is complete, ANY ENDS OF BOLTS PROTRUDING
BEYOND NUTS SHOULD BE CUT OFF AND/OR PEENED OVER
TO REMOVE ANY SHARP PROJECTIONS. Go over entire unit and
file smooth any sharp edges or projecitons that may have been
caused by rough handling in shipping or installation. T-Clamps are
designed for both one and two bolt connections. In many situations
only one bolt is required. See specific assembly instructions.
On products with platforms install 1 - 2 degrees off level to facilitate
water drainage
GENERAL MAINTENANCE INSTRUCTIONS:
Check MONTHLY for loose bolts, damaged, or broken parts.
Tighten and/or replace immediatly.
SPECIFIC ASSEMBLY INSTRUCTIONS:
Completely assemble bike rack.
1.
Position bike rack in proper position, mark footing holes, move
2.
bike rack to one side and dig holes.
Assemble anchor bolts to end supports and place bike rack in
3.
position over footing holes.
Pour concrete and wait 48 hours befor using equipment.
4.
Sheet 2 of 2
Rev 06/20/19
