111-201 PLAY HOUSE
Page
5
Rev. 05/21/2010
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 (314) 389-4140
www.sportsplayinc.com
ASSEMBLY AND INSTALLATION:
NOTE:
All threaded ends of bolts protruding beyond nuts must be cut off and/or
peened to eliminate sharp edges. No more than two threads should extend
beyond face of nut. All washers, “T” nuts and other fastener hardware
used on round pipe or tubing must be hammered down to conform to the
curved underlying surface to eliminate catch points. DO NOT tighten nuts
more than hand-tight until entire assembly is completed.
STEP 1
Mark footing holes per layout drawing on page 4. Dig the holes per the
footing drawing on page 3. (8 holes 2’ deep)
STEP 2
Start with one shell upside down and attach the two grilles by inserting a
5/16” nut through a 3/8” washer and into the grille. Then insert a 5/16”
x 2” bolt through a 5/16” lock washer the shell, grille and into the 5/16”
nut. Then move the shell into the proper position over the footing holes.
(see drawing on page 1 and below for help with this step).
STEP 3
Attach second shell following the procedure in step 2. Then attach the
Angle bracket where the two Grilles meet with the 1” bolt, lock washer,
flat washer and button head nut.
