Sportsman GEN4KDF, Инструкция по эксплуатации

Страница: 34 / 35

GEN4KDF Portable Dual Fuel Generator
34
(2) Any warranted part that is scheduled only for regular inspection in the written instructions required by subsection
(e) must be warranted for the warranty period defined in Subsection (b)(2). A statement in such written instructions
to the effect of “repair or replace as necessary”
shall advise owners of the warranty coverage for
evaporative emissions related parts. Replacement within the warranty period is covered by the
warranty and
will not reduce the period of warranty coverage. Any such part repaired or replaced under warranty
must be warranted for a time not less than the remaining warranty period.
(3) Any warranted part that is scheduled for replacement as required maintenance in the written instructions required
by subsection (e) must be warranted for the period of time prior to the first scheduled replacement point for that
part. If the part fails prior to the first scheduled replacement, the part must be repaired or replaced by the engine
manufacturer according to Subsection (4) below. Any such part repaired or replaced under warranty must be
warranted for a time not less than the remainder of the period prior to the first scheduled replacement point for the
part.
(4) Repair or replacement of any warranted part under the warranty provisions of this article must be performed at no
charge to the owner at a warranty station.
(5) Notwithstanding the provisions of Subsection (4) above, warranty services or repairs must be provided at all
manufacturer distribution centers that are franchised to service the subject engines.
(6) The owner must not be charged for diagnostic labor that leads to the determination that a warranted part is in fact
defective, provided that such diagnostic work is performed at a warranty station.
(7) Throughout the emissions control system’s warranty period defined in Subsection (b)(2), Buffalo Corp must
maintain a supply of warranted parts sufficient to meet the expected demand for such parts
and must obtain
additional parts if that supply is exhausted.
(8)
Manufacturer-approved replacement parts that do not increase the exhaust or evaporative emissions
of the engine or evaporative emission control system must be used in the performance of any
warranty maintenance or repairs and must be provided without charge to the owner. Such use will
not reduce the warranty obligations of
Buffalo Corp.
(9)
The use of add-on or modified parts may be grounds for disallowing a warranty claim made in
accordance with this Article.
Buffalo Corp.
will not be liable under this Article to warrant failures of
warranted parts caused by the use of an add-on or modified part.
(10 ) Buffalo Corp shall provide any documents that describe that Buffalo Corp.'s warranty procedures or policies within
five working days of request by the Executive Officer.
(d) A list of all emission warranty parts list must be included with each new engine or equipment subject to this Article, The
emission warranty parts list shall include all parts whose failure would increase exhaust and evaporative emissions, and
contains the following parts
Exhaust Emission Warranty Parts List.
(1)
Fuel Metering System
(i) Carburetor and internal parts (and/or pressure regulator or fuel injection system).
(ii) Air/fuel ratio feedback and control system.
(iii)Cold start enrichment system.
(iv) Fuel Tank.
(2) Air Induction System
(i) Controlled hot air intake system.
(ii) Intake manifold.
(iii) Air filter.
(3) Ignition System
(i) Spark Plugs.
(ii) Magneto or electronic ignition system.
(iii) Spark advance/retard system.
(4) Air Injection System
(i) Air pump or pulse valve.
(ii) Valves affecting distribution of flow.
(iii) Distribution manifold.
(5) Catalyst or Thermal Reactor System
(i) Catalytic converter.
(ii) Thermal reactor.
(iii) Exhaust manifold.
(6) Particulate Controls
(i) Traps, filters, precipitators, and any other device used to capture particulate emissions.