PAGE 15 OF 22
Elevator and Rudder horn attachment
Locate control horn.
Hold in position on
elevator in line with
the push rod and
on the edge of the
hinge line.
Drill two holes with a pin vice drill.
Place the bolts through and fit backing
plate and tighten.
Trim the excess bolt length off with side
cutters.
Apply a small amount of thin C/A on to
the backing plate bolts to lock in position.
Repeat process for Rudder.
AILERON JOINING WIRE
Sit the plane on its wheels.
Measure in from the fuselage side along
the aileron 100mm and mark the spot.
Mount a control horn in a reverse way to
the aileron horn.
(Pointing backwards with the holes
lining up over the trailing edge of the
aileron).
Measure the same on the bottom of the
top wing aileron.
Fit a control horn to the bottom of the
top aileron in the same fashion as you
did for the bottom aileron
Connect a clevis to both ends of the
push rod supplied.
Fit the push rod to the second hole in on the control surface.
Set the bottom aileron to a neutral position.
Adjust the clevises till you get the top ailerons in a neutral position.
When the aileron servo is powered up with the radio there will be more up then down aileron this is normal.
