501-5962
3
• Loosen the two adjustable hub assemblies by untightening the two knobs.
4
• Move the upper support leg until the SR3162 is set approximately to the same
angle as in Step 2 that closely resembles your vehicle. Hold the SR3162 in
place to check for correct adjustment. Only the upper support leg may rest on
glass. Tighten the hubs by tightening the two knobs.
5
• The bike support arms should be angled slightly upward about 15°.
6
ATTACH UPPER HOOKS
• Once you have the SR3162 assembled to it’s proper setting, place it on the
vehicle. Now attach the two upper hooks into the slot at the leading edge of
the trunk or hatch lid. Adjust the straps lengths so the SR3162 stays in place
on the car in the desired position. The bike support arms should now be tilted
slightly upward as Step 5.
CAUTION: Make sure that all the hooks are attached to metal, not fiberglass, plastic or glass.
Max 5 1/2" 165mm
