SportDOG Sport Hunter 1325, Руководство по эксплуатации

Страница: 16 / 24

16 1-800-732-0144
PROGRAM THE SYSTEM FOR THREE AND SIX-DOG OPERATION
A SportDOG ™ Add-A-Dog ® receiver(s) must be purchased to train additional dogs.
Please refer to the back cover for compatible Add-A-Dog Collar Receivers for this system.
THREE DOG OPERATION
1. Program the Remote Transmitter to mode 4 or 5 in the toggle switch black/up position
(see page 14).
2. With the toggle switch in the
black/up position, program the fi rst Collar Receiver:
A. Turn the Collar Receiver off.
B. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off in
4-5 seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin
its normal fl ashing. If this occurs, start over and repeat from
A .
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light
fl ashes 5 times. If the Receiver Indicator Light does not fl ash 5 times, start over and repeat
from A .
3. Program the second Collar Receiver using A through D above, but using the Lower Button in
place of the Upper Button.
4. Program the third Collar Receiver using
A through D above, but using the Side Button in place of
the Upper Button.
SIX-DOG OPERATION
Program the Remote Transmitter to mode 1 or 2 in the toggle switch orange/down position (see
page 15).
For six-dog operation repeat above Steps 2-4 with the toggle switch in the black/up position for dogs
1, 2, and 3; then fl ip the toggle switch to the orange/down position, and repeat above Steps 2-4 for
dogs 4, 5 and 6.
CHANGE ID CODES
An ID Code is the signal identifi cation between the Remote Transmitter and Collar Receiver. Each
is programmed in 1 of 2,000 ID Codes from the factory. The SportHunter
® 1325 has the fl exibility to
program two or more Remote Transmitters to the same ID Code, allowing them to both control one
Collar Receiver. There are 64 programmable ID Codes available.
TO MANUALLY PROGRAM A REMOTE TRANSMITTER’S ID CODE FOLLOW THESE STEPS:
1. Turn the Intensity Dial to V/T with the toggle switch in the up position, and then press and release
the Mode Button on the back of your Remote Transmitter. This does not change the mode, so the
current mode will still be active after the ID change is complete.
2. Once the Mode Button is released, the Transmitter Indicator Light will illuminate solid green and
stay on for 15 seconds.
3. While the green Indicator Light is on, turn the Intensity Dial to select the 1st digit of the ID and then
press and release the Side Button. The green Indicator Light will fl ash rapidly confi rming selection.
4. Again, while the green Indicator Light is on, turn the Intensity Dial to select the 2nd digit
of the ID and then press and release the Side Button. The green Indicator Light will fl ash
rapidly confi rming selection. The 2nd digit is optional and, if not desired, wait until the green
light turns off and refrain from pressing the Side Button.
ST
E
P
::
09
ST
E
P
::
08