15
SPORTDOG.COM
STEP :: 08
CHANGE ID CODES
An ID Code is the signal identification between the Remote Transmitter and Collar Receiver. Each is programmed in 1 of
2,000 ID Codes from the factory. The SportTrainer® SD-425E and SD-425S-E have the flexibility to program two or more
Remote Transmitters to the same ID Code, allowing them to both control one Collar Receiver. There are 64 programmable
ID Codes available.
TO MANUALLY PROGRAM A REMOTE TRANSMITTER’S ID CODE
1. Turn the Intensity Dial to V/T and then press and release the Mode Button on the back of your Remote Transmitter. This does
not change the mode, so the current mode will still be active after the ID change is complete.
2. Once the Mode Button is released, the Transmitter Indicator Light will illuminate solid green and stay on for 15 seconds.
3. While the green Indicator Light is on, turn the Intensity Dial to select the 1st digit of the ID and then press and release the Side
Button. The green Indicator Light will flash rapidly confirming selection.
4. Again, while the green Indicator Light is on, turn the Intensity Dial to select the 2nd digit of the ID and then press and release
the Side Button. The green Indicator Light will flash rapidly confirming selection. The 2nd digit is optional and, if not desired,
wait until the green light turns off and refrain from pressing the Side Button.
5. At the end of 15 seconds, or after the second press of the Side Button, the green Indicator Light will turn off and the ID of
the Remote Transmitter will be updated. At this point, the Remote Transmitter will be in the same mode it was in prior to
setting the ID.
6. Upon changing the ID Code, you will need to match the Collar Receiver to the Remote Transmitter (see STEP 06).
TO RETURN THE REMOTE TRANSMITTER TO THE FACTORY ID
1. Turn the Intensity Dial to V/T and then press and release the Mode Button on the back of your Remote Transmitter. This does
not change the mode, so the current mode will still be active after the ID change is complete.
2. Do not press any buttons and wait until the green Transmitter Indicator Light turns off.
3. You will need to match the Collar Receiver to the Remote Transmitter (see STEP 06).
NOTE: Removing the battery will also return the Remote Transmitter to the factory ID.
ACCESSORIES
To purchase additional accessories for your SportDOG® SportTrainer® SD-425E Remote Trainer or SD-425S-E Stubborn Dog
Remote Trainer, contact the Customer Care Centre or visit our website at www.sportdog.com to locate a retailer near you.
