SportDOG Brand SD-BASKET-R, Руководство пользователя

Страница: 7 / 15

12 1-800-732-0144
WWW.SPORTDOG.COM 13
Using Li-Ion technology, the Receiver only requires a 2 hour charge. It is not harmful to let the unit charge
more than 2 hours.
TO TURN THE RECEIVER ON
Press and release the Receiver On/Off button. Unit will emit ON tone.
TO TURN THE RECEIVER OFF
Press and hold the Receiver On/Off button for 3 seconds. Unit will emit OFF tone.
To extend the life between charging cycles, turn off the Receiver when it is not in use.
NOTE: Approximate battery life between charges is 80 hours, depending on frequency of use.
RECHARGEABLE BATTERIES
• The Transmitter and Receiver contain Lithium-Ion (Li-Ion) batteries; never incinerate, puncture, deform,
short-circuit, or charge with an inappropriate charger. Fire, explosion, property damage, or bodily harm may
occur if this warning is not followed.
• Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries accordingly.
• Batteries should never be removed from the battery compartment for charging.
• Do not charge the batteries in areas with high temperature (100° F+).
• The rechargeable Lithium Ion (Li-Ion) batteries are not memory sensitive, do not require depletion before
charging and cannot be over charged.
• The batteries come partially charged from the factory, but will require a full charge before the first use.
• When storing the unit for long periods, remember to regularly give batteries a full charge. This should be
done once every 3 to 4 months.
• You should expect hundreds of recharge cycles from your batteries. However, all rechargeable batteries
lose capacity over time relative to the number of recharge cycles they experience. This is normal. If your
operating time drops to half of the original life, contact the Customer Care Center to purchase a new battery.
• The batteries should last for a period of 3-5 years. When a battery needs replacement, you can order a new
pack by calling our Customer Care Center at 1-800-732-0144. Please do not open the Transmitter or Receiver
until you have received the replacement.
MATCHING RECEIVER(S) TO THE TRANSMITTER
Prior to use, you must match your Receiver(s) to the Transmitter.
In Normal Mode, the Transmitter can control up to 4 Receivers at a time, with up to 9 devices attached to each. In
Expanded Mode, the Transmitter can control to up to 36 Receivers.
NORMAL MODE
1. Make sure the Receiver is turned off and the
Transmitter is set to Normal Mode (see page 10).
2. Press and hold the Receiver’s On/Off button until it
beeps. Keep pressing (about 5 seconds) until a “P”
appears on the Receiver’s LCD screen. The module is
now in “Program Mode”.
3. Press one of the Launch Signal Buttons (1-4) to assign
a number to the Receiver.
4. The “P” on the Receiver will flash, indicating it has
accepted the programming signal and a 1-4 icon
will appear in the upper right corner, identifying
the Receiver’s number. All the devices attached to a
particular Receiver will be launched using that Receiver’s number.
5. Repeat this process if you have purchased multiple Receivers.
EXPANDED MODE
1. Make sure the Receiver is turned off and the Transmitter is set to Expanded Mode (see page 10).
2. Press and hold the Receiver’s On/Off button until it beeps. Keep pressing (about 5 seconds) until a “P” appears
on the Receiver’s LCD screen. The module is now in “Program Mode.”
3. To assign each Receiver a unique identity, use the Launcher Selection Up/Down Buttons to select the device
position (0-8) then press the Launch Signal Button 1-4.
4. The “P” on the Receiver will flash, indicating it has accepted the programming signal.
5. A 1-4 icon will appear in the upper right corner and a number 0-8 will appear in the middle of the Receiver’s
LCD screen. These numbers identify the Receiver’s unique identity.
6. Repeat this process until each Receiver has been assigned a unique identifier.
STE
P
:: 0
6