SP6 Installation and Setup V0.91
Sportdevices © 2019
20/NOV/2019
2.2
SAFETY: General Power Safety
By default, if other values are not specified all SportDevices equipment are rated for
230 VAC / 50 Hz.
(115 VAC units will have a specific label for that)
Observe the following guidelines when connecting your equipment to a power source:
Check the voltage rating before you connect the equipment to an electrical outlet to
ensure that the required voltage and frequency match the available power source.
Do not plug the equipment power cables into an electrical outlet if the power cable is
damaged.
To prevent electric shock, plug the equipment power cables into properly grounded
electrical outlets. If the equipment is provided with a 3-prong power cable, do not use
adapter plugs that bypass the grounding feature, or remove the grounding feature
from the plug or adapter.
If you use an extension power cable, ensure that the total ampere rating of the
products plugged in to the extension power cable does not exceed the ampere rating
of the extension cable.
If you must use an extension cable or power strip, ensure the extension cable or power
strip is connected to a wall power outlet and not to another extension cable or power
strip. The extension cable or power strip must be designed for grounded plugs and
plugged into a grounded wall outlet.
If you are using a multiple-outlet power strip, use caution when plugging the power
cable into the power strip. Some power strips may allow you to insert a plug
incorrectly. Incorrect insertion of the power plug could result in permanent damage to
your equipment, as well as risk of electric shock and/or fire. Ensure that the ground
prong of the power plug is inserted into the mating ground contact of the power strip.
Be sure to grasp the plug, not the cable, when disconnecting equipment from an
electric socket.
2.3
SAFETY: If Your Device Gets Wet
CAUTION: Before you begin any of the procedures in this section, see the SAFETY:
General Safety section of this document.
CAUTION: Perform this procedure only after you are certain that it is safe to do so. If
the device is connected to an electrical outlet, turn off the AC power at the circuit
breaker, if possible, before attempting to remove the power cables from the
electrical outlet. Use the utmost caution when removing wet cables from a live
power source.
1.
Disconnect the AC cord from the electrical outlet, and then, if possible, disconnect the
AC cord from the device.
2.
Turn off any attached external devices, then disconnect them from their power
sources, and then from the device.
3.
Contact SportDevices support ([email protected])
Limited Warranties:
warranty is limited to normal usage of the device, any fault
caused by inappropriate usage or accident will not be covered
