Spohn & Burkhardt SV1C Series, Руководство по эксплуатации

Страница: 79 / 98

79
Spohn & Burkhardt
3.2. Electrical connection
Attention!
Make sure all cables are laid correctly without kinks or points where they can chafe.
Make sure the cable markers are not removed and mark new cables so they can be iden-
tified. Fasten together the cables using cable ties, if necessary. While laying cables, pay
attention to any bending radii specified by the manufacturer.
Attention!
Cables are routed from below.
During installation, make sure the cables are not trapped or kinked.
Danger!
Make sure the control stand is secured against tipping and is stored on a suitable surface
to prevent injuries and damage to the control stand.
Danger!
Make sure all console lids are secured against unintentional opening and the inserts are
firmly fixed to prevent injuries and damage to the control stand.
Note
The control stand is wired to terminals or plugs/sockets according to the requirements of
the operating organization.
The customer's electrical connection is made specifically according to the requirements
of the operating organization and the related circuit diagrams, (see chapter 11. “Reference
documents”, page 95).
1. Disconnect the system from the supply of electrical power.
Figure 28.
18 18 18
14
15
15
14
15
15
14
15
15
53585
53577
49649
53678
53585
53577
Electrical connection: opening spacer
2. Remove the two locking screws (
18
) on the spacer (
4
) see Figure 28 .
3. Carefully tip the seat in the direction of the hinges (
15
), make sure the control stand is secured
against tipping back and is placed on a suitable surface.