s
POD SE BLUETOOTH MODULE INSTALLATION INSTRUCTIONS
Revision
1.0
PAGE 2
WWW.4X4S-POD.COM
TO RESET THE PIN
On the Module
Remove the jumper from the top two middle pins of JP1.
Install the jumper on the top left two pins of JP1 (Position 2).
Wait 5 seconds.
Reinstall the jumper on the top two middle pins of JP1 (Position 1).
On the App
Input “0000” in both the Old and New PIN spaces and “Update.”
Or for a new device or app reinstalled, the PIN has been
set to “0000” as factory should connect.
CUSTOMIZATION
In the settings menu, you can customize:
The names of the switches
The features of the switches (Dim, Momentary, Strobe, and Flash)
The color of the switches
You can also select which Source to control if you have multiple sources
TROUBLESHOOTING
(If the app will not connect)
1. Be sure that no other sPOD Bluetooth devices are within 400 feet and that no other devices are running the app.
2. Close the app completely on the device.
3. Pull the 2-amp fuse from the SE Source Board and wait 30 seconds then reinstall the fuse.
4. Start the vehicle
’s engine and start the app then follow the standard procedure to connect.
Jumper
Position 1
Position 2
