Splosh Wash Splosh 2, Руководство пользователя, Страница: 9 / 13

7
Follow these steps after each time you refill your tank:
1. Fill the tank with clean water. Do not use any products containing detergents.
2. Connect the hose to the motor pump case.
3. Connect the nozzle to the hose.
4. Press the on/off switch to start the unit when using the built-in battery.
When using the 12V connection, plug it into car cigarette lighter or other external
power port, then press the on/off switch, the unit will automatically switch to use
the power from 12V connections instead of its built-in battery.
5. Direct the pressure nozzle into the tank.
6. Turn the power on and run for approximately 30 seconds or until a steady stream
of water is present.
7. Turn off the power.
NOTE: Please start the engine while using the device if you are not sure whether the capacity
of the car battery is sufficient.
Automatic Shutoff
When the trigger is released, the dynamic pressure shuts the motor off automatically. When
the trigger is pressed, the pressure drop automatically activates the motor and pressure is
formed once again with a slight delay. To ensure correct automatic shutoff operation, the time
interval between trigger release and engagement must not be less than 5-10 seconds.
Shutting down your Splosh #2:
1. Turn off the switch on the base or lock it by holding the button for over 5 seconds.
2. Pull trigger on spray nozzle to relieve any water pressure in hose or spray nozzle.
3. Disconnect hose from unit.
4. Disconnect nozzle from hose.
5. Press spray nozzle to remove excess water.