7
General Maintenance
Warning:
always disconnect the plug from the power supply before any maintenance is
started.
1.
Water Filter: Check the water filter on the motor base is free from debris. Clean the
filter when necessary.
2.
Nozzle Clogged: A clogged nozzle will cause the operating pressure to be too high
causing the Splosh #1 to surge. If this happens turn unit off:
•
Turn the unit off, pull trigger on spray nozzle to relieve pressure, remove nozzle
from hose.
•
Clean the spray nozzle with the nozzle. (See Diagrams 1&2 below).
•
Flush wand assembly backwards with water or compressed air.
•
If pressure is still too high, repeat steps 1-2.
3.
Lubrication: No lubrication is required for this pump. Silicone grease may be added
to hose connector O-rings if connecting becomes difficult.
4.
Add some silicone grease to the spray nozzle if it has not been used for a long
time.
To Clean Spray Nozzle
For battery:
§
Do not store the unit in elevated temperature for an extended period of time.
§
Store the unit in a dry, cool and well-ventilated place, protect from direct exposure
sunlight.
