Split-fire 3203, Руководство пользователя, Страница: 17 / 23

OPERATION
Warm the Honda engine to operating temperature before
splitting wood. Move the knife back and forth 2 or 3 times to
ensure there is no air in the system.
Make sure that you have read and understood all safety
recommendations before operating the machine.
If any unnecessary noise occurs stop operation immediately
and check for damage. If nothing can be seen bring it to a
dealer to inspect. If there is no dealer in your area, contact
Split-fire Sales Inc. to discuss the problem.
Take a break every couple hours. Continuous work can create
extra stress which can lead to an accident.
STORAGE
Important! When storing your log splitter special attention
should be drawn to the areas listed below.
After each use, make sure that the inside of the frame is clean.
Special attention should be drawn to the cylinder and slider.
Looking from cylinder side of the log splitter you must be able
to see light through the four corners of the tube. Wood chips
and dirt can fill this up causing very high pressure. There are
different ways to clean this out. If you do it regularly and
everything stays dry in the frame you can blow it out with
compressed air. If everything is wet in there you can take a
pressure washer or hose to clean it out. Lastly you can use a
small hooked rod to pull or push the chips out.
Keep knife closest to engine or 3 point hitch when in storage.
If storing for a long period of time you can spray a layer of light
grade oil inside the frame and on the bed to prevent rusting.
If your machine is equipped with an engine, read that manual
as well for storage tips.
15