Street Rod Footswitch Operation
1. Clean/Overdrive Switch - LED on indicates Clean Channel -- Led off indicates OD Channel
3. Overdrive 1 / Overdrive 2 Switch
2. Mode Switch
- LED on indicates OD2 gain boost -- LED off indicates OD1
- LED on indicates 1st gear LED off indicates 2nd gear
Overdrive 1/ Overdrive 2
Clean/Overdrive
Mode
Footswitch connections -- Two 1/4" TRS plugs on a 25' cable
Setting up the Amplifier:
After unpacking your new amp, Turn the amp around so the back faces you. Remove the four screws to
remove the back cover of the amp. You will find the tubes packaged tightly on the left side of the Amp.
Carefully remove the package and remove the tubes. You will have three preamp tubes and four power
section tubes.
Power Section Tubes:
Tubes are marked with tube ratings! Use this number to re-order matched tubes so you will not have to re-bias.
There is a “key” guide to align the tube into the socket. Starting with the tube socket on the
far right, Line up the key with the slot in the socket, From the top of the tube, firmly press
the tube into the socket until the base of the tube is flush with the Socket. Insert these tubes into the tube
sockets. The tubes are matched so you may install them in no particular order. After you install a tube
carefully hold the tube spring retainer and stretch it over the top of the tube and center it. These are light
metal and can bend. If you happen to bend them you can shape it to the tube while its installed. Reinstall
the rear cover and get ready to fire this monster amplifier to life!
WARNING:
Please Check the Voltage selector on the back for proper Voltage selection! Please check the volume
control levels on all channels before powering on. After you plug in the amplifier, Flip the power switch
down to turn on. Wait for a minute for the tubes to warm, then turn on the Standby switch. The Amp is ready
for explosive guitar sounds!
This Amplifier will get VERY loud. Remember you only have one set of ears!
Limited Lifetime Warranty.
New Amplifiers are lifetime warranted to the original purchaser
against failure of materials and workmanship. No other warranty applies. Tubes, speakers and footswitches are
warranted for a period of ninety days. This warranty applies only if the amplifier has not been damaged by
accident, misuse or as a result of repair or modification. Splawn reserves the right to make any design changes
without notice or obligation to incorporate these changes in products previously purchased.
All warranty repairs are to be done by Splawn Amplification.
Splawn Amplification
115 South Gaston St.
Dallas, NC 28034
Dimensions
Combo 21” Wide, 21” Tall, 8” Deep, 50lbs
Head 25.5” Wide, 10” Tall, 8” Deep, 35lbs
Содержание super sport
Страница 1: ...OWNERS MANUAL Super Sport...
