6
Volume 8
Rear Panel
Power Supply, On/Off Switching
Be sure before connecting the Volume 8 to power that the rear-chassis voltage
supply is switched to the proper local rating (either 230 or 115 volts).
Above
all, before connecting any machines, take additional care to power down
all those to be used (and move the rear-chassis power supply switch of the
Volume 8 to the “down“ position). Finally, always use the following procedure
in powering up your assembly:
Always power on your Volume 8 fi rst before
the power amp or active speakers. When powering down, always power off
the power amp or active speakers before your Volume 8.
Not following this
sequence can result in ear or speaker damage from high level discharges.
The Volume 8 comes with a standardized 3-pole (grounded) IEC power cord
which is connected to the main power input socket (Mains Input).
.BJOT*OQVU
7
_)[
'
VTF
N
"
7
_)[
'
VTF
N
"
"7*43*426&%&$)0$c-&$53*26&/&1"40673*3
3*4,0'&-&$53*$4)0$,
% 0 / 0 5 0 1 & /
$ "65 *0/
7PMUBHF4FUUJOH'VTF3BUJOH
7
&-&$53*$"-1*/$0/'*(63"5*0/$0.1-*&48*5)
5"4$".45"/%"3%3&'&350."/6"-'03%&5"*-4
&-&$530/*$"--:#"-"/$&%
*/1654"/%0651654
E
#
4PVOE1FSGPSNBODF-BC
/JFEFSLSDIUFO(FSNBOZ
XXXTPVOEQFSGPSNBODFMBCDPN
4FSJBM/VNCFS
."%&*/(&3."/:
503&%6$&3*4,0''*3&03&-&$53*$4)0$,%0
/05&9104&5)*46/*5503"*/03.0*4563&
%*4$0//&$5."*/4#&'03&3&.07*/($07&3
5)*4&26*1.&/5.645#&&"35)&%
%#
8*3*/(
8"3/*/(
*OQVUT
UP
0VUQVUT
UP
.$)
.$)
.$)
.$)
.$)
.$)
.$)
.$)
.(/%$$PME ))PU
The electrical pin confi guration of the balanced DB 25 input and output
sockets comply with the TASCAM standard (see graphic below). The nominal
input level is +4 dB, other levels are transmitted 1:1.
DB 25 to XLR, TRS or RCA multicore cables are required for connection of input
and output signals. The eight channels of the DB 25 connector at one side
are routed to eight single XLR, TRS or RCA connectors on the other side. The
channel confi guration is free (input = output). Here are some common multi-
channel confi gurations:
SMPTE/ITU: L/R/C/LFE/LS/RS/L(t/o)/R(t/0)
DTS: L/R/LS/RS/C/LFE/L(t/o)/R(t/0)
Film: L/LS/C/RS/R/LFE/L(t/o)/R(t/0)
SDDS: L/LC/C/RC/R/LFE/LS/RS
Содержание VOLUME8
Страница 12: ...12 Volume8 Manual Volume8 English...