SPL Phonitor 2, Руководство пользователя

Страница: 24 / 31

24
IR Remote control
The volume potentiometer can be remotely controlled using any infrared (IR) remote control.
The special feature is that the Phonitor 2 learns your remote and not the other way around. You do not need a learn-
able remote control. Take, for example, the remote control of the CD player. Out of the many buttons there are two
you hardly use if at all. Assign Volume up / Volume down to these two buttons and let the Phonitor 2 learn them.
• While learning the IR remote control commands set the Output switch (9) to Mute.
VU meters light up red.
• Press the IR REMOTE LEARN button (18) on the rear of the unit. The Power LED now lights up
brighter.
• Point your remote control towards the VU meters (1) and push the button you wish to use
to lower the volume . The power LED lights up once per push. Press the same button repeatedly until the
power LED lights up three times within a short interval – programming this button is then completed.
• Point your remote control towards the VU meters (1) and push the button you wish to use to increase the
volume . The power LED lights up once per push. Press the same button repeatedly until the power LED
lights up three times within a short interval – programming this button is then completed.
(Learn mode ends automatically after the second button is learned.)
Output
Mute
Cr/A All
Matrix
Off
IR REM OTE
IR REMOTE
OUT PU T
OUTPUT
L
R
R
L
LEARN
R L R L R L
SO UR CES
SOURCES
2
2
L R
1
1
L R
Learning Volume Up/Down:
1. Press LEARN button below
2. Point your remote at VUs
and press a button for
VOLUME DOWN (LEDs flash 1x)
3. Repeat until LEDs flash 3x
4. Press a button for
VOLUME UP (LEDs flash 1x)
5. Repeat until LEDs flash 3x
XLRs
: balanced, Pin 2 = Hot (+)
For unbalanced operation
bridge Pin 3 to GND.
RCAs : Unbalanced, Tip = Hot (+) AVIS: RISQUE DE CHOC ÉLECTRIQUE • NE PAS OUVRIR
RISK OF ELECTRIC SHOCK
D O N O T O P E N
C AUTION
ON BOTTOM SIDE:
DIP S WITCH WIRING
This output can also drive balanced headphones
(Gender changer may be required).
3
3
Phonitor 2
~ 115V AC / ~230V AC
50 Hz / 60 Hz, P max. 35 W
Fuses:
Voltage Selection:
115V AC: T 1 A L 250 V
230V AC: T 500 mA L 250 V
1. Remove Fuse Holder
2. Flip Over 3. Reinstall
1 ON: 12dB
2 ON: 6dB 3 ON: RCA -10dBV to +4dBu
4 ON: Sources 1:1 to Output
Serial
Number
Made in Germany