SPL Neos 1010, Руководство пользователя

Страница: 9 / 26

9
Neos
Hook Up
Placement
Place the unit on a level and stable surface or mount it into dedicated rack frames. The unit’s
enclosure is EMC-safe and effectively shielded against HF interference. Nonetheless, you
should carefully consider where you place the unit to avoid electrical disturbances. It should
be positioned so that you can easily reach it, but there are other considerations. Try not to
place it near heat sources or in direct sunlight, and avoid exposure to vibrations, dust, heat,
cold or moisture. It should also be kept away from transformers, motors, power amplifiers
and digital processors.
Rack Mounting
Be sure that both above and below the machine you maintain a distance of 4-5 cm/2 inches
in order to eliminate electromagnetic or high frequency interference from other equipment.
Moreover, this will ensure adequate air circulation to prevent overheating. Do NOT locate
other machines that produce excessive heat below the unit.
The rear side of the machine
should be properly supported – especially when transport is involved.
Placement Of The External Power Supply
Do not place the external power supply on top of the Neos and vice versa. Place the external
power supply on a level and stable surface only. We recommend a distance of at least 50
cm/20 inches to avoid any interferences between the external power supply and the Neos
frame or other devices.
Choose a place that is easily accessible so that you can switch off the external power supply
quickly in case of an emergency.
Please mind the notes under “Power Connection” and “On And Off” on the next page.
Voltage Selector (External Power Supply)
Be very careful to check that the voltage selection switch is set to the correct local line
voltage position before using the unit (230 V position: 220-240 V/50 Hz, 115 V position:
110-120 V/60 Hz)!
When in doubt about a source, contact your dealer or a professional electri-
cian.
BEFORE you connect electrical power make sure that the VOLTAGE selector setting reflects
the correct local power line voltage.
Power connection and fuse
Connect the power cord to the MAINS INPUT socket of the external power supply. Transformer,
power cord and case connection conform to VDE, UL and CSA requirements.
The fuse is accessible from outside and placed right behind the flap right from the socket.
Fuse ratings are 2 A slow blow (230 volts) or 4 A slow blow (115 volts).
230V~50Hz | 2A slow
115V~60Hz | 4A slow
VOLTAGE | FUSE
Use slow blow fuse.