Marc One
7
Do not place the device in a location where it may come into contact with corrosive gases
or salty air. This may result in malfunction.
Before moving the device, remove all connected cables.
When setting up the device, make sure that the mains socket outlet you are using is easily
accessible. If some trouble or malfunction occurs, immediately turn off the power switch
and disconnect the power supply from the mains socket outlet. Even when the power
switch is turned off, electricity is still flowing to the product at a minimum rate. When you
are not using the device for a long time, make sure to unplug the power supply from the
wall mains socket outlet.
Connections
Before connecting the device to other devices, power down all devices. Before power on or
off the devices, set all volume levels to minimum.
Only use appropriate cables to connect the device with other devices. Make sure that the
cables you use are intact and comply with the electrical specifications of the connection.
Other connections can lead to health risks and damage the equipment.
Handling
Operate the controls and switches only as described in the manual. Incorrect adjustments
outside safe parameters can lead to damage. Never use excessive force on the switches or
controls.
Do not insert your fingers or hands in any gaps or openings of the device.
Avoid inserting or dropping foreign objects (paper, plastic, metal, etc.) into any gaps or
openings of the device. If this happens, power down immediately and unplug the power
supply from the mains socket outlet. Then have the device inspected by a qualified profes-
sional.
Do not expose the device to excessive dust or vibrations or extreme cold or heat (such as
direct sunlight, near a heater or in a car during the day) to prevent the possibility of causing
damage to the housing, the internal components or unstable operation.
If the ambient temperature of the device suddenly changes, condensation can occur (if for
example the device is relocated or is affected by a heater or air conditioning).
Using the device while condensation is present may result in malfunction. Do not power on
the device for a few hours until the condensation is gone. Only then it is safe to power on.
Cleaning
Disconnect the power cord from the device before cleaning.
Do not use any solvents, as these can damage the chassis finish. Use a dry cloth, if neces-
sary, with an acid-free cleaning oil.
Disclaimer
Windows® is a registered trademark of Microsoft® Corporation in the United States and
other countries.
Apple, Mac and Macintosh are trademarks of Apple Inc., registered in the U.S. and other
countries.
The company names and product names in this manual are the trademarks or registered
trademarks of their respective companies.
SPL and the SPL Logo are registered trademarks of SPL electronics GmbH.
SPL cannot be held responsible for damage caused by improper use or modification of the
device or data that is lost or destroyed.
Notes on Environmental Protection
At the end of its operating life, this product must not be disposed with regular
household waste but must be returned to a collection point for the recycling of
electrical and electronic equipment.
The wheelie bin symbol on the product, user manual and packaging indicates that.
For proper treatment, recovery and recycling of old products, please take them to applica-
ble collection points in accordance with your national legislation and the Directives
2012/19/EU.
The materials can be reused in accordance with their markings. Through reuse, recycling of
raw materials, or other forms of recycling of old products, you are making an important
contribution to the protection of our environment.
Your local administrative office can advise you of the responsible waste disposal point.
This directive only applies to countries inside the EU. If you wish to discard devices outside
the EU, please contact your local authorities or dealer and ask for the correct method of
disposal.
WEEE-Reg-No.: 973 349 88
EN
DE
