SPL Kultube 2049, Руководство пользователя

Страница: 9 / 24

9
Again, while Kultube‘s housing is EMV safe and protects against HF interfer-
ences, proper placement of the unit is very important. Before connecting the
Kultube or any other equipment turn off all power. Adjust the voltage setting
on the back so that it corresponds with your local electrical power conditions.
The following graph shows the correct wiring for connecting unbalanced
signals to the balanced XLR connectors:
Alternatively unbalanced signals can be connected with mono Jack connec-
tors to the balanced Jack sockets.
Analog XLR and TRS jacks
Symmetrical XLR and TRS jacks are used for analog in- and outputs. An analog
mixing console is generally connected here (Insert Send/Return). Since the
TRS and XLR jacks are wired in parallel, unbalanced operation of the TRS
jack will have the same effect on the XLR jack and vice-versa. The Kultube is
configured for a nominal level of +4dBu and can handle an input level of max.
25 dBu, with max. +23 dBu available on the output. It is recommended to drive
the Kultube with a signal level of between 0 dBu and 12 dBu – this being the
optimum drive range for signal processing in which also the signal-to-noise
ratio is the best.
General Advices
Connections
Sockets & Rear Switch
Connections
Input Output
balanced unbalanced balanced unbalanced
1=GND
2=hot (+)
3=cold (-)
1 2
3
1 2
3
1 2
3
1
2
3